Instrumentation Cables Suppliers, UAE

Instrumentation cables carry low-level analogue and digital signals between field instruments (transmitters, sensors, analyzers) and control system marshalling cabinets, requiring superior shielding against electromagnetic interference. They are essential in every GCC process plant where hundreds or thousands of measurement points feed into DCS and PLC systems. Procurement teams must specify correct pair/triad configurations, shield types, and fire performance ratings to ensure signal integrity.

0 suppliers found

Active:ASME Clear all

No suppliers match these filters

Try clearing some filters — or post your requirement and let matching suppliers come to you.

Request Quotes Clear all filters

Post your requirement, get quotes from multiple suppliers

Tell us about instrumentation cables in UAE and receive competitive quotes from verified suppliers — free, fast, and no obligation.

Get Free Quotes

Instrumentation cables connect field-mounted sensors, transmitters, and analyzers to the distributed control system (DCS) or programmable logic controllers (PLCs) in process plants across the UAE and Saudi Arabia. These cables carry milliamp and millivolt signals that demand excellent noise immunity to maintain measurement accuracy.

Standard instrumentation cables are constructed as twisted pairs or triads (for grounded thermocouple circuits) with individual and overall aluminium-polyester foil shields and drain wires. Conductor sizes of 0.5 mm2, 0.75 mm2, or 1.5 mm2 are common, with pair counts ranging from 1 to 24 pairs per cable. For HART-enabled 4-20 mA instrument loops prevalent in GCC plants, shielded twisted pair cables with characteristic impedance suitable for HART communication frequency (1,200 Hz) must be specified.

Fire performance is critical: most ADNOC and Saudi Aramco specifications require instrumentation cables to meet IEC 60332-3 flame retardancy, and critical safety instrumented system (SIS) circuits often mandate fire-resistant cables per IEC 60331 to maintain signal integrity during a fire event for at least 30 minutes.

When procuring instrumentation cables for GCC projects, specify overall cable diameter tolerance carefully, as cable glands and conduit entries must be sized accordingly. Order 10 to 15 percent extra length to account for field routing adjustments common in plant construction. Verify that the cable manufacturer provides individual pair identification markings (numbered or colour-coded) consistent with the project wiring schedule to reduce installation errors and commissioning time.

Frequently Asked Questions — Instrumentation Cables

What shield type is best for instrumentation cables in GCC process plants?

Individual aluminium-polyester foil shields on each pair plus an overall foil or braid shield over all pairs provide the best noise rejection. This dual-shield configuration is standard in Saudi Aramco (SAES-P-108) and ADNOC specifications. The individual shields isolate each signal loop, while the overall shield protects against external interference from power cables and radio sources.

Should we use pairs or triads for thermocouple extension cables?

Triads (three-conductor twisted groups) are used for grounded thermocouple circuits where the third conductor serves as a drain or guard wire. For ungrounded thermocouples and RTDs, twisted pairs are standard. Always match the thermocouple extension cable conductor material (Type K, J, T, etc.) to the thermocouple type to avoid measurement errors.

How do we prevent signal interference in long instrumentation cable runs?

Maintain minimum 300 mm separation from power cables, use individually shielded pairs with single-point grounding at the control room end, avoid routing near VFDs or welding equipment, and ensure all cable shields are properly terminated at the marshalling cabinet. For cable runs exceeding 200 meters, consider increasing conductor size to 1.5 mm2 to reduce loop resistance.